Can't find what you're looking for? Click here for more search options
For downloadable catalogs, click here.
RetroArcade.us Crane Machine Prize Sensor Cable for RA-CRANE-KIT, Prize Sensor Cable OnlySpecifications: Length: Approximately 3 feet 6 inchesNOTE: This is only for the prize sensor cable. Prize sensor is NOT included.Installation Instructions:The white connector plugs into the crane prize sensor. It is keyed to only plug in one way. The pinout is etched on the crane prize sensor where this white connector plugs in letting you know which wire is for what purpose. The loose wires then get connected to the crane PCB through the wiring harnesses plugged into J4(P4) and J3(P3). They push and snap into these existing white connectors as follows:GND (Ground) - J4(P4), PIN 112V (12 Volts) - J4(P4), PIN 9 (PIN 9 may have an existing wire. If so, use PIN 8)S (Signal) - J3(P3) PIN 1
UPC: 709402207696
SP: crane machine kit, crane machine, crane gantry, claw machine, claw game, the claw machine, arcade machine, RA-CRANE-KIT, prize sensor, sensor, cable
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl) phthalate (DEHP), which is know to the State of California to cause cancer. For more information go to P65Warnings.ca.gov
Terms and Conditions | Return Policy | About Us | Downloadable Coupons | Partners | Privacy Policy | © 2024 Holland Computers Inc.
Use of this site signifies your acceptance of Holland Computers Website Terms and Conditions and Privacy Policy.