Can't find what you're looking for? Click here for more search options
For downloadable catalogs, click here.
RetroArcade.us Crane Machine Prize Sensor for RA-CRANE-KIT, Prize Sensor and Prize Sensor CablePrize Sensor Specifications:Length: 7.6250 inchesWidth: 2.0000 inches (without mounting holes)Width: 2.8750 Inches (with mounting holes)Height: 0.9375 inchesPrize Sensor Cable Specifications:Length: Approximately 3 feet 6 inchesInstallation Instructions:The white connector plugs into the crane prize sensor. It is keyed to only plug in one way. The pinout is etched on the crane prize sensor where this white connector plugs in letting you know which wire is for what purpose. The loose wires then get connected to the crane PCB through the wiring harnesses plugged into J4(P4) and J3(P3). They push and snap into these existing white connectors as follows:GND (Ground) - J4(P4), PIN 112V (12 Volts) - J4(P4), PIN 9 (PIN 9 may have an existing wire. If so, use PIN 8)S (Signal) - J3(P3) PIN 1NOTE: This item includes both, the crane prize sensor (RA-CRANE-PS-SENSOR) and the crane prize sensor cable (RA-CRANE-PS-CABLE).
SP: crane machine kit, crane machine, crane gantry, claw machine, claw game, the claw machine, arcade machine, RA-CRANE-KIT, prize sensor, sensor, cable
WARNING: This product can expose you to chemicals including Di(2-ethylhexyl) phthalate (DEHP),which is known to the State of California to cause cancer. for more information go to www.P65Warnings.ca.gov
© 2023 Holland Computers Inc.